Arduino Adapter For Raspberry Pi


Arduino is a massive ecosystem, if there's a way for the Raspberry Pi GPIO interface to adapt to Arduino pinouts, it is possible to use the Pi together with vast Arduino shields and hardware/software resources. The ARPI600 is just intended for this.

What's more, the ARPI600 also support XBee modules, make it easy to add wireless feature to your great project.

Supported Pi:

Raspberry Pi 1 Model A+

Raspberry Pi 1 Model B+

Raspberry Pi 2 Model B


  • Compatible with Arduino UNO, Leonardo, easy to connect with various Arduino shields
  • XBee connector for connecting various XBee modules
  • Sensor interface for connecting various sensors
  • Onboard USB TO UART for serial port debugging, also can be configured as XBee USB adapter
  • Onboard ADC, 10 bit, 38KSPS, 11 channels (6 channels for Arduino interface, 5 channels for sensors)
  • Onboard RTC


1.Arduino connector : for connecting Arduino shields

2.ICSP interface : Arduino ICSP

3.XBee connector : for connecting XBee communication modules

4.Sensor interface : for connecting sensors

5.Raspberry Pi connector : for connecting Raspberry Pi


7.TLC1543 : AD converter

8.PCF8563 : RTC


10.32.768KHz crystal : for RTC

11.Power indicator

12.XBee state LED

13.XBee and Arduino interface RESET button

14.XBee EASYLINK button

15.RTC battery holder : for CR1220 button battery

16.TLC1543 reference voltage configuration jumper

17.RTC jumper

18.UART jumper

when connecting P_RX and CP_TX, P_TX and CP_RX respectively, USB TO UART is connected to Raspberry Pi serial port

when connecting XB_RX and CP_TX, XB_TX and CP_RX respectively, USB TO UART is connected to XBee serial port

when connecting XB_RX and P_TX, XB_TX and P_RX respectively, Raspberry Pi serial port is connected to XBee serial port

19.Arduino AD selection jumper

short 2 and 3 : Arduino A0-A5 as AD input

short 1 and 2 : Arduino A0-A5 as digital control

20.Arduino I2C selection jumper

short the jumper : Arduino A4-A5 as I2C control (the A4-A5 of Arduino AD selection jumper should be opened)

21.Arduino SPI selection jumper

short 1 and 2 : Arduino D11-D13 as SPI control (default)

short 2 and 3 : Arduino D11-D13 as digital control


Please visit wiki page for more info about this product.

For technical support, please post your questions to our forum

Technical details

Dimensions150mm x105mm x29mm
WeightG.W 101g



Source: Arduino Adapter For Raspberry Pi

About The Author

Muhammad Bilal

I am highly skilled and motivated individual with a Master's degree in Computer Science. I have extensive experience in technical writing and a deep understanding of SEO practices.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top