GameMamePiBoy

cramming a RPi A+ and a retro-pie installation into a classic gameboy case

With the acquisition of a PiZero today, the project will now focus around using that. It's more or less the same spec as the A+ but half the size and with double the RAM (YAY!) There are a few extra things to think about now, mainly that the Zero has no native audio out, so I'll have to either pull it off the GPIO, or use an HDMI audio spitter.

About

The GameMamePiBoy is inspired by the Adafruit PiGrrl project which has a printable Gameboy style case which holds a raspberry pi model b (the original) and uses a very nice 320×240 TFT screen. this was the project that I wanted to do when I first discovered the Southampton maker/hackerspace So Make It. However when it came time to start getting the required parts, I decided to make the parts work in an actual O.G. gameboy case, just like the one I had as a kid, playing endless rounds of tetris and Super Mario Land on.

Case Parts

Not wanting to desecrate a perfectly good working gameboy, I went on the hunt for a broken gameboy to act as a donor, and as luck would have it, a member of one of the retro buy and sell groups on facebook was selling 2 broken units, so thinking I'd be able to salvage at least one good one and use the other as basis for this conversion, I snapped them up.

Unfortunately, the screens in both are toast and the only way to repair a screen is from another unit as there are no more screens available, which means the second may be a candidate for GameMamePiBoy 2 😉

Screen

So one of the annoyances of the RPi B is that the USB ports hang over the side of the board by a fair amount. The B is already the perfect size for fitting into a gameboy but for these ports. The B+ and B 2 are better candidates, but it's still a tight fit, so given that with this project I'd only want to play games up to the level of SNES, a RPi A+ seems a perfect candidate as it gives me more freedom to align the Pi.

In order for the PiTFT to fit in, a lot of internal screw posts have to be removed and some internal easing with a dremel. the view port aperture also needs opening up to get it to be visible as the 2.8″ screen is a bit bigger than the original. 

It became apparent that all but two of the screen area screw posts would have to be cut down and a custom mount for the screen made up. This was done in tinkercad and 3D printed at So Make It, taking 6 print attempts so far to get the model just right. Print 1 was done on So Make It's PLA Cerberus delta printer but the printer isn't currently printing dimensionally accurately, though the print finish was very good. So Make It also has a Lulzbot TAZ which has just been upgraded with an E3D hot end. The second attempt was made on the TAZ but this highlighted errors in the model. After a couple more iterations, the final model has produced a print which fits perfectly. To make everything fit now, the header pins will need to be de-soldered from both the Pi and the TFT.

Source: GameMamePiBoy


About The Author

Muhammad Bilal

I am highly skilled and motivated individual with a Master's degree in Computer Science. I have extensive experience in technical writing and a deep understanding of SEO practices.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top