Minimal RaspberryPI base

This is a plan for immobilising a Raspberry PI in a domestic environment, without children or pets, in order to run it without killing it with static.  I have no idea whether this level of precaution is required, but it's been about two weeks, and it hasn't died so far.Minimal RaspberryPI base

Step 1: Parts

I used a block of 4×2 construction timber, left over from a painting job, some 25mm x 8g screws, left over from a gate numbering job, some anti-static bags cadged from a computer shop, and a Raspberry PI B.

Anti-static bags come in three sizes, in order from small to large: memory, disk and motherboard; I ended up using one of each.

Step 2:

Turn a disk-sized bag inside out, so that the writing that would identify the disk isn't exposed on the surface.

Step 3:

Make a fence of screws, through the anti-static bag, into the timber, around the Raspberry PI, with at least one on each edge, avoiding the places where you need to plug things in.

(Slightly unrelated, when you're plugging in the SD card, turn the board over, to check that it's all the way in, because the insertion force is quite high.)Minimal RaspberryPI base schematich

Step 4:

If you need to transport the PI, you could protect it with a strip of memory-sized anti-static bag and hold it in place with a rubber band, then wrap it in a motherboard-sized anti-static bag.  I have tested this a lot less than I've tested the rest of this plan.

 

 

 

For more detail: Minimal RaspberryPI base


About The Author

Ibrar Ayyub

I am an experienced technical writer holding a Master's degree in computer science from BZU Multan, Pakistan University. With a background spanning various industries, particularly in home automation and engineering, I have honed my skills in crafting clear and concise content. Proficient in leveraging infographics and diagrams, I strive to simplify complex concepts for readers. My strength lies in thorough research and presenting information in a structured and logical format.

Follow Us:
LinkedinTwitter

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top