Power supply for function generator

Over the course of developing and testing the function generator I have needed a dual polarity power supply.  I have been using a bench power supply that I made some time ago.  It has two variable voltage outputs and I am linking the +ve terminal of one supply to the 0V of the other supply to create a dual +/- supply.  This is fine but I also needed a way of powering the arduino uno that I am using to control the AD9835 function generator PCB.  During the course of my testing in a massive ‘ooops' moment, I managed to wire up something incorrectly and destroyed my arduino uno!  This is to be avoided obviously and I only have myself to blame!

Note to self….when testing or developing a project ensure that connecting power to the device under test is as simple and stress free as possible. A random mass of different coloured wires is Not acceptable! Power supply for function generator
Further note to self….ensure that the power supply you are using cannot supply too much voltage or current to the device under test!  This way no magic smoke or expensive and unnecessary catastrophic failures will be observed!

To stop this happening I have designed a power supply which meets all of these requirements and ensures that this shouldn't happen again – I am of course assuming that I won't make a similar mistake again and that is a significant assumption!  I often make mistakes….

The power supply is a linear power supply with the following features:

Take an input of 230V 50Hz AC (British AC line voltage)

and provide the following output:

+12V output with at least 500mA to power the op-amp filter and amplifier section
-12V output with at least 500mA to power the op-amp filter and amplifier section

+9V output with at least 500mA to power the arduino and display and control section – I know I could have used 5V here but I wanted to use slightly greater than 5V so that I am correctly powering the on board linear regulator already present on an arduino.  I'm going to use the 5V output for everything else.

With the power and functional specifications sorted I had a look at which parts I had available.    I didn't have any switching regulator devices handy and I didn't want to introduce more switching noise into my circuit.  I haven't made many switch-mode power supplies and didn't want to use this topology of power supply.   I did have plenty of linear regulators including a LM7809 and a LM7812 for positive voltage regulation and a LM7912 for negative voltage regulation.Power supply for function generator schematic

Here are the datasheets for those devices:

Fairchild version of 78XX positive linear regulator datasheet

Fairchild version of 79XX negative linear regulator datasheet

I have been through the design and implementation of a linear power supply in previous blog posts so I'm not going to repeat myself again.  If people are interested please look at the posts concerning power supplies for how to design linear power supplies

 

For more detail: Power supply for function generator


About The Author

Ibrar Ayyub

I am an experienced technical writer holding a Master's degree in computer science from BZU Multan, Pakistan University. With a background spanning various industries, particularly in home automation and engineering, I have honed my skills in crafting clear and concise content. Proficient in leveraging infographics and diagrams, I strive to simplify complex concepts for readers. My strength lies in thorough research and presenting information in a structured and logical format.

Follow Us:
LinkedinTwitter

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top