Raspberry Pi is a great project computer, it's cheap ($35), runs Linux (or Risc OS) and has lots of resources available aroudn it.
When mine arrived, I didn't really know what to use it for, but then it hit me: I can build an emulator box for all the NES and SNES games that I loved to play as a child.
The goals for this project were:
- Build an emulator box to play NES/SNES games
- Use the original NES case
- Use the original NES controllers
I picked up a non-working NES from eBay, it came with two controllers and a game. So much for the game, it will be of no use, but the rest is what I needed. The NES is really easy to take apart and just uses standard screws.
The power and A/V connectors were attached to the main circuit board block, it was a bit of a pain to pull them out and a part of the PCB got damaged in the process. No big deal on the damage, I didn't need the whole PCB intact.
The front panel with the on/off and reset buttons and the on LED is removed. I added single pin Dupont connectors on all of the wires except for the power button, there I soldered on single pin headers. The idea with the power button is to have the pins plug into the wiring I will have running from the power socket and either close the circuit or not.
A quick test and the LED works! I did have to splice in a 10K resistor in the LED wiring. This should be visible on the white wire above, the resistor is mostly covered by heat shrink.
I cut the positive (red) wire from the power port to the USB hub about half way and added the single pin Dupont connectors into it, this is where the power switch plugs in.
The wiring looks like this, the positive wire is basically spliced and the negative wire is left alone:
|
(- wire from port)——————————————-|[###] = Dupont connector
The USB hub, A/V block and the front panel all connected and in place.
For more detail: Raspberry Pi in a NES Case – Part 1 – Wiring up the front panel and external connectors
