Reading and writing from GPIO ports from Python

This tutorial covers the setup software and hardware to read and write the GPIO pins on a Raspberry Pi running the latest Raspbian operating system.

We will showing how to read from a physical push-button from Python code, and control an LED.

Related categories: Tutorial

Step 1: Install Python development tools

Open a terminal on the Raspberry Pi either via the desktop or by SSH'ing in (default credentials are pi/raspberry).

Run the following commands to install some basic Python development tools:

sudo apt-get update sudo apt-get install python-dev python-pip sudo pip install –upgrade distribute sudo pip install ipython

Reading and writing from GPIO ports from Python

Step 2: Install GPIO library

While the default Raspbian image does include the RPi.GPIO library, we would like to install a newer version to get access to a newer API for callbacks.

sudo pip install --upgrade RPi.GPIO

As of this writing the current version of 0.5.0a but you may see a more recent version later.

Step 3: Connect the button

View schematic.

For the first part of this we will be using a single push button. Normally the top two pins and bottom two pins are not connected, but when pressing the button a connection is formed, allowing current to flow. We will put a 330 Ohm resistor in-line with the switch to protect the GPIO ping from recieving too much current.

I have used GPIO4 for this example, but any GPIO pin not otherwise in use will work fine, just update the pin number in later code samples.

Important: Never connect GPIO pins to the 5V power supply

The two 5V supply pins on the breakout board are very useful for powering complex chips and sensors, but you must take care to never accidentally use them to directly interface with the GPIO pins. The GPIO system is only designed to handle 3.3V signals and anything higher will most likely damage your Raspberry Pi

Reading and writing from GPIO ports from Python Schematic

Step 4: Read the button from Python

Remember that you must run your interpreter as root (ex. sudo ipython).

First we need to configure the GPIO pins so that the Raspberry Pi knows that they are inputs:

import RPi.GPIO as GPIO
GPIO.setmode(GPIO.BCM)
GPIO.setup(4, GPIO.IN, pull_up_down=GPIO.PUD_DOWN)

The pull_up_down argument controls the state of the internal pull-up/down resistors. Looking back at the circuit diagram above you can see that when the button is not pushed, the GPIO pin is effecitvely not connected to anything. This is referred to as “floating”, and it means that the voltage there can be unpredictable. A pull-down adds an additional resistor between the pin and ground, or put simply forces the voltage when the button is not pressed to be 0.

With the pin configured we can now do a simple read of the button:

print GPIO.input(4)

This should output False if the button is released and True if the button is pressed. Try it a few times each way to make sure you wiring and configuration is correct.

 

For more detail: Reading and writing from GPIO ports from Python


About The Author

Ibrar Ayyub

I am an experienced technical writer holding a Master's degree in computer science from BZU Multan, Pakistan University. With a background spanning various industries, particularly in home automation and engineering, I have honed my skills in crafting clear and concise content. Proficient in leveraging infographics and diagrams, I strive to simplify complex concepts for readers. My strength lies in thorough research and presenting information in a structured and logical format.

Follow Us:
LinkedinTwitter

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top