Short circuit tracer/finder uses low power

This Design Idea presents a low power short circuit finder that capitalizes on the ear’s sensitivity to changes in frequency. The heart of the circuit is a voltage-to-frequency converter (based on Linear Tech’s AN45, Figure 13, by Jim Williams), which converts millivolt-level DC voltages to a wide range audio frequency output.

Short circuit tracer finder uses low power

The excitation signal is created by low power DC-DC regulator U1. This circuit provides a 100mV output, current limited to 100mA by the 1O output resistor. This voltage should be low enough that it won’t hurt or bias sensitive circuits.

Four-wire probes with Kelvin connections near the tips are used because of the low voltages. The bias current flows through the probes and the shorted part of the circuit, creating a very low voltage drop between the probe tips.

The Kelvin-connected sense wires apply that low voltage to the voltage-to-frequency converter (see LT AN45 for a description of that circuit). The frequency increases as the circuit resistance increases, and can be tuned to your preference using potentiometer VR1.

The output of the voltage-to-frequency converter is applied to flip-flop U4 to produce nice squarewave output signals to drive audio transducer SP1.

When the probes are removed from the circuit, the output frequency goes up to about 6kHz. To prevent insanity, the output of the error amplifier, U2, is used to disable the audio.

To use the device, you first null the probes by probing the circuit that’s shorted, and adjusting VR1 to a frequency that you like. Then, moving the probes along the conductor, the frequency will increase as you move away from the short, or decrease as you get closer to it. The pot provides a lot of frequency range so that it can be adjusted as desired. With the probes shorted together, the frequency can be nulled to zero. In that case, the sensitivity is about 100Hz per milliohm. If the 0O frequency is adjusted to 1kHz, the sensitivity is about 1kHz per milliohm.

Read more: Short circuit tracer/finder uses low power


About The Author

Ibrar Ayyub

I am an experienced technical writer with a Master's degree in computer science from BZU Multan University. I have written for various industries, mainly home automation and engineering. My writing style is clear and simple, and I am skilled in using infographics and diagrams. I am a great researcher and am able to present information in a well-organized and logical manner.

Follow Us:
LinkedinTwitter

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top