I worked on creating a Internet connected
humidistat last week using my open source WiFi relay project as platform. We observe quite dry air at our house, I suspect this is due to the fact that we use fan coils for heating/cooling. Humidity levels at home are usually below the 30% mark, which poses a health risk along with uncomfortably dry air. I’ve found these interesting charts that got me convinced I need to do something:
Low humidity helps spread virus/bacteria over air.
The comfortable zone for humans depends on the temperature, here is what it looks like for most of us:
We own a ultrasonic humidifier, but it has no setpoint, just on/off with intensity setting. Also, I’d like it to work only in certain times, not all of the time, so that called for using the WiFi thermostat scheduling function, only re-worked to take the humidity as to determine on/off state rather than temperature:
I realize there are homes with exact opposite problem, i.e. humidity is too high. For that reason I have a “Dry” function to use with air drier as well so the relay will function using opposite logic i.e. activate when humidity is exceeded.
The project uses a DHT22 temperature sensor mounted to the side of the enclosure for better ventilation and reliable reading:
I threw in a ultra-cheap I2C OLED status display to get a visual reading. Milling the box so that the OLED shows was pretty nasty, hated it. I cut a piece of paper and placed it on top of the cover, below the transparent lid to cover up for the lousy milling job
For more detail: DIY Internet connected smart humidifier
Current Project / Post can also be found using:
- raspbery pi humidifier on off