ICStation STM8 Minimum System Board

1.Features

1.Control chip is STM8S003F3P6

2.All pins can be available,and mark pins,but male pins should be welded by customers in person(Customers should provide your own male pins)

3.Support SWIM debug mode

ICStation STM8 Minimum System Board4.There be two power supply mode,USB MINI wire and 2.54 male pin

5.You can choose crystal oscillator outside.

6.PD3 pin,connect with a LED lamp,in order to debug.

2.Application Range

STM8S003F3P6 is based on 8 bit frame structure,it has abundant resource.

3.Specification

  • Chip:STM8S003F3P6
  • Voltage:3.3V/5V(USB port)
  • PCB size:38.5*28mm

7.Download instructions

Hardware equipment:ST-Link downloader (including four DuPont line),PC,STM8 minimum system board
Application software:IAR or STVP
Wiring method:

ICStation STM8 Minimum System Board Schematic

ST-Link

STM8 minimum system board

VCC

VCC

GND

GND

SWIM

SWIM

RST

RST

Attention:ST-Link selects 3.3V output,the USB port of STM8 minimum system board,connect with 5V power.

For more detail: ICStation STM8 Minimum System Board

Current Project / Post can also be found using:

  • STM8S003F3 connect schem
Scroll to Top
Scroll to Top
Read previous post:
All Weather Solar Powered Raspberry Pi

Here I am going to show you how to set up a solar panel, buck convertors and batteries to create...

Close